The manufacturer of the fully automatic extraction ring machine shares the following issues regarding the filling machine.

The manufacturer of the fully automatic extraction ring machine shares the following issues regarding the filling machine.
The manufacturer of the fully automatic extraction ring machine has learned that there are many edible oil filling machines in use. The filling degree of the edible oil filling machine is the core part of the equipment. Frequent use can easily cause faults to the equipment. Now, the manufacturer of the fully automatic press and lift ring machine will share some problems of the filling machine. 1. If the filling volume of the edible oil filling machine is unstable, varying from much to little, what should be done?

Check whether there is any air leakage at the connection point between the oil inlet of the filling machine and the steel wire hose. If there are air bubbles at this point, use iron wire or steel wire to tightly fix it until there is no air leakage.
2. Check whether there are any dirt or particles inside the copper one-way valve. If so, remove them.
3. Check whether the magnetic switch on the cylinder is properly fixed. Be careful not to exert too much force.
4. Replace the V-shaped sealing ring inside the cylinder.
5. The oil filling machines mostly adopt the flowmeter type filling method. Check for any faults in the flowmeters.
II. What should be done if oil drips from the filling port of the edible oil filling equipment?
Adjust the four bottom corner screws of the filling machine properly, and make sure they do not move.
2. Check if there are any particles inside the filling valve. If so, remove them.
III. How to adjust if the filling speed of the edible oil filling machine is too slow?
Check whether the intake pressure is normal. If it is not normal, check whether the air passage is blocked and whether the air compressor is powered on and operating normally.
2. Adjust the silencing throttle valve adjustment screw of the electromagnetic valve. Pull it out quickly and then screw it in slowly.
3. The intake pressure can be adjusted to 0.4 to 0.5 Mpa.
4. Check if there are any impurities blocking the filling valve. If so, remove them.
This is what the manufacturer of the fully automatic pressurized ring machine has shared about some issues with the filling machine. If you have these problems, you can follow the above requirements to repair them. For more information about the fully automatic pressurized ring machine, you can follow Kuijin Automation Technology Co., Ltd.